wireengineer

That feeling when you realize you have been doing dinner and anime with the group every week for more than a decade....

@RobertDaleSmith Yep working on encoders now

@wireengineer Nuon again? I’ve got a lot of this mapped out.

found something

Encoder is working but it does not show up on boot. Needs a hotplug to be detected for some reason. Good enough to start taking bus traces and emulating.

Things afoot

When you know from the factory it will not start....

And it's off the trailer. Let the cleaning begin

And done for the day

Believe it or not that was my first guess at center of gravity

@SecureThisNow @Hyr0n1 Ooo where are they at... Have a need....

Don't let @Hyr0n1 near the AI machine unattended. Certainly not when he is bored. That said, he nailed it 🤣 Evidence:

Controls unwired and cabinet removed. Just the quill to remove before I have to get back into sketchy stuff.

Started disconnecting the control cabinet

@KirkMattwood Hopefully. will be a while before it runs. Just trying to break it down enough to get off the trailer

@wireengineer No question. It had to be done. Looks like a cool mill!

Off to make questionable decisions

Correction very. But ways look good

Sketchy not sketchy

Y reassembled and adjusted. Just need to figure out scale mounting and lock screws

Table back on and y lead screw thrust bearings adjusted. Need to do the gib and rear bearing mount yet

Finished adulting early so got some more of the lathe assembled. X lead screw, gibs adjusted, and tailstock on. Future me will hate current me as one of the locking set screws on the gibs is rounded out.