ukrepeaters

GB7IV Off air due to being found dead in rack, likly cause is relays in the remote shutdown interface.

was found to be dead in the rack, its therefore been removed from site to be repaired, the fault likely caused by the high SWR of the previous aerial. Before being refitted we will go through all the duplexers and filters with the correct test kit and realign. /G4MYS /G4MYS

the South Hampshire Fusion repeater is totally off air while we establish what is wrong, and what to do about it. /G4MYS /G4MYS

The South Hampshire Repeater Group fusion repeater was found dead in the rack, however the repeater itself has no fault, the likely cause yet to be investifgated and repaired is the Remote shutdown unit. /G4MYS

GB3WG-L Off air due to GB3WG DR2X power fault.

GB3NZ Powersupply failure, suspected heat. Expected to be down for a few days.

GB3WG The DR2X repeater has to go back to yaesu for repair, as not giving any output, this could be off air for several weeks.

MB7IDP Down due to faulty transmitter

GB7ME Demonstrated working by M0IJS & G1VAJ

The gateway will be offline from 2130 tonight for approximately 24 hours due to work at the house. /2E0UCW

MB7IBW 10m gateway up and running and connected to Yorkshire Net UK

GB7PD fusion repeater off the air while the site is converted to wind/solar power and disconnected from mains supply by the commercial owners of the site. I will give updates when I have them. GW4OZU /GW4OZU

was found to be dead in the rack, its therefore been removed from site to be repaied, the fault likly caused by the high SWR of the previous aerial. Before being refitted we will go through all the duplexers and filters with the correct test kit and realine. /G4MYS

MB6DN Back online after move to Jurassic Fibre ISP

MB6ITM Gateway now back on the air.

GB7PD Unresponsive to any calls. Unknown reason for failure.

the South Hampshire Fusion repeater is totally off air while we establish what is wrong, and what to do about it. /G4MYS

MB7ANT Currently running on low power while I configure the software/hardware.

GB3WN Very Low Power Test mode.

GB3GB Very Low power Test Mode.