Gary M1EGI

And now GB3CT 😁

@M0DTS getting into GB3VL 😁

@M0DTS Yeah, those spurs are annoying!

@M1EGI VL traces at 1Ms, local spurs there annoyingly.

SDR Television working very well 'on the edge' of GB3EY DVB-S2 reception tonight at home, 3m dish doing all the work 😉 Comparable to Minitiouner now 👍

New ATV-Repeatermap.com for the representation of analog and digital operating modes. On a contact page, you can report new repeaters, changes, deletions, and general messages. Page is in German, but can switched to English.

@nerdsville Please share how you get on! Nice to see activity on the up again...

There is some local ATV activity at the moment and spotted an old Amatrad analogue satellite receiver on eBay sold as spares or repair. Freed the stuck standby button and it lives. Now to see if I can receive GB3LX

I've been playing with several GPS antennas over the Christmas holidays, more posts to come with updates on the project where they are required...

Lucent Technologies Timing Enhanced Active GPS Antenna Made in USA, 2010

LBE-1420 can be a HAM radio beacon with directly modulated Q65 output. All you need is a low-pass filter, an amplifier and an antenna. Here is 1.297GHz GB3LBE beacon currently on air. Email us if you want to try the Q65 mode beta test firmware for LBE-1420.

Second round of our traditional #BlackFriday game! Retweet (Repost?) and Like to participate! Check our generous offer and get an instant 25% off on all our products! airspy.com/purchase Good luck all!

Alien tech?

@MehdiHacks Maybe use a Adalm Pluto using SATSAGEN software. Either 3rd or 5th harmonic mode...

I don't have equipment for testing a 27 GHz device :/ For now I'm doing generic analysis, until I get/build some sort of 27-30GHZ signal source, to be able to test the device functionality, and trace the signal path. Any ideas?! Maybe using the 2nd harmonic of a 14GHZ signal?

Rate my RF test setup

#24GHz #GHz_bands Linear Power Amplifier 2 WATT ebay.us/m/IjnNFN Ready-to-Transmit @sskmbk @g8kmh @g1dfl_pete @mac_jk1dgg @G4SJH_Barry @eb3frn @G8GKA @2ftg1 @HHolsink @otackie @kuwahara82 @k6sqy @F5AYE @UKGHZ @2ftg1

@uhf_satcom Have you tried a reverse image search?

I need to find these persons. They left their phone on the Waterloo to Bournemouth train on Thursday evening, think they got off at Winchester around 10PM.

Black magic to create new 47GHz devices 😇😇 #GHz_bands #hamradio #hamr

ON0HVL Beacon 24ghz signal into Kent 24ghz SDR this morning about 09.15

Something a little unusual for @Phonemast. This Three 4G/5G antenna has been up a couple of years. The little antenna halfway up it is new though. It belongs to Netmoore Ltd & reads the new Yorkshire Water smart meters via their 868 MHz LoRaWAN Network.

A short vid on the #FARS #FinningleyARS #13cms source and #3cm #RX project, ideal for #QO100 #10ghz @amsatdl @AmsatUK #ghz #amsat

DIY Looking for #GHz_bands WAVELAB type XP ⏩ ebay.pl/itm/3170455831… ⏪🔬🛠️@UKGHZ @2ftg1 @JH1OQH @HHolsink @eb3frn @ea3hmj @g0lbk @g8kmh @G8GTZ @G8GKA @g1dfl_pete @f5len @F5HRY @sskmbk @sp_vhf_c

The next RF Revolution: Printed Wave Guide 😎 Brings cost down and allows so far impossible designs! #Aaronia #Microwave #RF